RC equipment (196)
| Discussions | Replies | Latest Activity |
|---|---|---|
 Question regarding battery pack for Turnigy 9X 2.4 GHz 8Ch ReceiverHi, I want to buy a battery pack for my Turnigy 9X 2.4 GHz 8Ch Receiver and I was told I need it to be between 4.5V and 6.5V. Is there any… Started by Antoine Audy-Julien |
2 |
on Thursday Reply by Dany Thivierge |
 Spektrum AR8000... two bad receivers?I purchased a DX8 that came with an AR8000 8-channel receiver. I'm trying to use it for an ArduCopter that was built by jdrones. The first… Started by Aaron Yates |
4 |
on Wednesday Reply by j.hrauda |
 "Spektrum dx7s" ArduPlane mode switches / selection?Can anyone help me setup my "Spektrum DX7s" to enable all 6 flight modes? The instructions seem to be a bit different than the DX7 instruc… Started by Kevin Finisterre |
0 | Jan 26 |
 RC GraupnerI have an RC Graupner MX-20 Hott with GR-24. how can I connect the telemetry on the GR-24 to receive it? Started by Andrea |
3 |
Jan 24 Reply by Colin Bouriquet |
Tunigy 9x Firmware with Mavlink stackHello, I release a new firmware for Turnigy 9x, You can use telemetry from APM (watching battery voltage and GPS informations). You can t… Started by Gerard Valade |
8 |
Jan 23 Reply by Monroe |
 TURNIGY 9X Flashing problemCould someone help with a tip? After several hours of trying to work and searching for a solution on the Internet, I am about out of option… Started by Tom in ON |
8 |
Jan 23 Reply by Brian McClue |
computer tx interface (PCTx) buddy cordTo control my servos from a computer ground station I'm considering buying the PCTx for $50 (www.endurance-rc.com). Is that a good choice?… Started by natester |
1 |
Jan 20 Reply by natester |
Hitec 2.4 equipmentI am getting my Arducopter and want to use my Royal EVO 12 that has a Hitec 2.4 Module. Has anyone used any Hitec equipment or even a Roya… Started by Steve S |
0 | Jan 13 |
 Preferred Quad RC Controller?Managed to build my Quad and do basic testing with only a 2 Channel Controller that's 25 years old. I'm looking to upgrade. Since I'm using… Started by SonicPet07 |
6 |
Jan 13 Reply by SonicPet07 |
Servo switch wiringI have this servo switch, https://store.diydrones.com/ServoSwitch_V10_p/br-0007-01.htm Can someone please elaborate on the wiring? I thi… Started by Greg |
0 | Jan 4 |
Top Content
Groups
-
ArduCopter User Group
459 members
-
ArduPlane User Group
288 members
-
ArduCopter (traditional …
76 members
-
ArduPilot (legacy) User …
76 members
-
Moderators
48 members
-
ROS User Group
25 members
-
Team Prometheus
3 members
© 2012 Created by Chris Anderson.
