Hi pilots,
A new autopilot arrived - ARSOV UAV Board V1.1 ( pls see the attached picture ).

Developed and manufactured by ARSOV RC technology. The controller is based on UDB3 hardware design and is fully compattible with MatrixPilot code from either UDB projest ( http://code.google.com/p/gentlenav/ ) or ARSOV RC Technology .

Special thanks to Bill Premerlani, Peter Hollands, Ben Levitt and Riccardo Kuebler !

ARSOV UAV V1.1 is fully hardware supported by ARSOV RC Technology, has very small size - just 30x45mm. and all connectors are factory soldered.

Some specs:

1. Inputs - 5 ( IN1-IN4, RE8 );

2. Outputs - 5 ( OUT1-OUT3, RE0, RE2 );

3. Gyros - IDG500 and ISZ500;

4. Accelerometer - MMA7361L;

5. GPS ( EM406A or MediaTEK3329 ) connector;

6. ICSP connector;

7. Telemetry/OSD 4 pin connector;

8. Very small size - just 30x45mm. Could fit into small planes/fuselages;

9. Could be ordered fully programmed.

The ARSOV UAV Board V1.1 has been tested many times with many firmware settings and work just fine !
More you could read on my website www.arsovtech.com , but please excuse me for it is not completely ready....I'm working hard on it and think the website will be ready soon.

The IMU daughterboard:

Best regards friends

Nick