Replies to This Discussion

Permalink Reply by Chris Anderson on February 23, 2010 at 2:41pm

Yes. If you run it through the Ardustation power regulator, that will probably be dropped down to 4.2v, but that should still high enough to run the board without trouble. Or, since the power is already regulated, you can connect it directly to a V+ pin and bypass the onboard power regulator entirely.

• ▶ Reply

Permalink Reply by WhiteQueen on February 24, 2010 at 8:48am

Then that is exactly what I shall do. I will connect the 5v regulated power supply directly to the V+ pin on the ArduStation, and celebrate as I bask in the warming glow of blinking LEDs.

• ▶ Reply

Permalink Reply by Taylor Cox on April 9, 2010 at 12:43am

Hey Rich, this is what I would suggest doing. You can just get this barrel jack 9v battery adapter :) here is the link
http://www.sparkfun.com/commerce/product_info.php?products_id=9518

That way all you need to power the ardustation is the 9v battery.

• ▶ Reply

Permalink Reply by John Holloway on June 24, 2011 at 6:17am

Hi

I have just finished the assembly of the Ardustation and have uploaded the script, does the screen have to be powered separately as mine does not have any display when powered up.

Just to confirm I have connected a 9 volt power supply to the power socket and have a green led light on the lower board and get a single beep.

Cheers

John

• ▶ Reply

Permalink Reply by John Holloway on June 24, 2011 at 8:00am

Hi Again

I have just been reading through earlier posts on the site and have adjusted the pots on the control board and my display has popped up, so all is good.

cheers

John

• ▶ Reply

• ‹ Previous
• 1
• 2
• Next ›
• Page