AttoPilot XYZ Horizon Sensor info

Hi,

I have an AttoPilot XYZ Horizon Sensor and an Arduino. I would like to know how to connect the sensor to the Arduino. Does anyone knows the pin layout? What I get as output from the XYZ sensor? A variable tension or a variable resistance? Any help is appreciated.

Riccardo

Views: 164

▶ Reply to This

Replies to This Discussion


ModeratorPermalink Reply by Chris Anderson on December 18, 2009 at 8:18am
They're essentially identical to the Paparazzi sensor. This page will tell you what you need to know.
Permalink Reply by Riccardo Tacconi on December 18, 2009 at 9:47am
Thanks for your reply. I cannot see any description of the pins. There is a schema saying +5 and roll and pitch output but not a correspondance of the pins.

ModeratorPermalink Reply by Chris Anderson on December 18, 2009 at 10:36am
This post may help
Permalink Reply by Riccardo Tacconi on December 18, 2009 at 11:05am
Yes it helps indeed :-)

RSS

Contests

Season Two of the Trust Time Trial (T3) Contest has now begun. The third round was a reliablilty/aerial photography round for both planes and copters, which is now closed. Stay tuned for the next round, beginning soon.

A list of all T3 contests is here. 

 

Top Content 

1 Brainstorming Specifications.

Brainstorming Specifications.
2 What do you think the APM should do on fail safe

What do you think the APM should do on fail safe
3 ArduCopter 2.5 released!

ArduCopter 2.5 released!
4 Control Software

Control Software
5 Hexa-copter found after failed attempt of delivering cell phones to inmates of a Brazilian penitentiary

Hexa-copter found after failed attempt of delivering cell phones to inmates of a Brazilian penitentiary

Groups

© 2012   Created by Chris Anderson.

Badges  |  Report an Issue  |  Terms of Service