Discussions

MP issue when using PX4 to drive camera gimbals

Posted by Thomas J Coyle III on September 4, 2013 at 7:13am

There appears to be a problem with the MP when attempting to program the PX4 gimbal servo channels for roll, pitch and yaw.

According to the Arducopter Wiki RC9 is the PX4 channel to use for roll, but does not appear in the MP roll gimbal selection. The only RC channels that are available for roll are RC8 and RC10.

Regards,

TCIII Admin

You need to be a member of diydrones to add comments!

Join diydrones

Email me when people reply –

Replies

Vaibhav Kumar September 4, 2013 at 7:32pm

I thought I was the only one who had this problem.

Eagerly waiting for the update!!!!
Developer

Michael Oborne September 4, 2013 at 4:20pm

I will add rc9

This reply was deleted.

Activity

#xg { position:relative;top:120px; } #xn_bar { top:120px; }

Hello, you need to enable JavaScript to use diydrones.

Please check your browser settings or contact your system administrator.