Hey everyone.
I recently purchased an APM2.5+ and have just started building a plane for it, however I can't seem to get APM to output anything to any servos. The sensors all seem to read fine and the radio and pwm test show data should be going through. But there's just no output.
This is the first time I've set it up and I'm powering it from usb.
Is there anything i need to do to get the outputs to work? I saw some other threads about no output problems, but this is the first time I've turned the APM so I just wanted to check.
Thanks,
Andrew

@Andrew,
Did you purchase your APM2.5+ from 3DR or is it a clone?
Regards,
TCIII

Permalink Reply by Bill Bonney on January 29, 2013 at 9:18am You need to power it from a battery connected either to an ESC which is connect to the outputs or a standalone BEC connected to the outputs. The USB will not power the servos.
Season Two of the Trust Time Trial (T3) Contest has now begun. The fourth round is an accuracy round for multicopters, which requires contestants to fly a cube. The deadline is April 14th.24 members
185 members
51 members
1295 members
687 members
© 2013 Created by Chris Anderson.
Powered by
