Discussions

open pilot and the DIY power dist board

Posted by Kevin Goodman on October 28, 2011 at 2:49pm

Hello,

So I am stumped on how to bring the openpilot board together with the DIY drones power dist. board.

The power dist. board has the 4 sets of the 3 prong connections for the esc's. But the openpilot has them as well. Can anyone explain to me what I need to do next?

I feel I have everything in rout or in my possession to get my quad in the air. I just need some advice on how to bring it all together.

So far what I have in hand

1-VC-450 quad frame

1-DIY drones power dist. board

1-open Pilot CC board

1-Spektrum DX6i also the AR6210 6-ch DSMX receiver

2-10"x4.5 prop sets w/ adapters

In rout...

4-NTM Prop Drive series 28-26A 1200kv /250w

4-Turnigy Plush 30amp speed controls

2-Turnigy 3000mAh 3S 20c Lipo's

 

any help/ direction would be much appreciated

You need to be a member of diydrones to add comments!

Join diydrones

Email me when people reply –
Follow

Replies

  • Franco Nogarin November 20, 2011 at 5:45pm

    I am pretty sure that the 3 conductor for ESC are simple pass through points, it is very strait forward. You should ask in the OpenPilot forums!

    Franco

     

  • AVS November 20, 2011 at 2:00am

    did you work this out? still need help?

This reply was deleted.

Activity