Scratch built Ardupilot

Hi guys, i´ve been reading everything i could find about autopilot setups, and i noticed most people got their board already assembled, well i got one too and didn´t receive it yet..... but then i decided why not build a new Ardu-board with the stuff that i have at home.... that could fit into my 0.40 trainer fuselage.
So i decided to give it a try and the result is here, it will be improved in the future with a new look but for now its ok, check picture files attached !

cheers

Views: 14

Attachments:

▶ Reply to This

Replies to This Discussion

Permalink Reply by copperclad on February 25, 2009 at 2:18pm
Hi Gil
good work , very nicely done , thanks for posting , cheers
Permalink Reply by Gil on March 6, 2009 at 10:57am
Thanks !
Permalink Reply by Sesan FESOBI on March 23, 2009 at 6:04pm
Hi Pal,
I commend your effort. How much does each of the board weigh? Could these devices you have put together be effectively used as part of the flight control system for a small model aircraft with wing span of 1.8 metres

RSS

Contests

Season Two of the Trust Time Trial (T3) Contest has now begun. The third round was a reliablilty/aerial photography round for both planes and copters, which is now closed. Stay tuned for the next round, beginning soon.

A list of all T3 contests is here. 

 

Top Content 

1 What do you think the APM should do on fail safe

What do you think the APM should do on fail safe
2 ArduCopter 2.5 released!

ArduCopter 2.5 released!
3 Brainstorming Specifications.

Brainstorming Specifications.
4 Control Software

Control Software
5 Housekeeping note: Kevin Finisterre

Housekeeping note: Kevin Finisterre

Groups

© 2012   Created by Chris Anderson.

Badges  |  Report an Issue  |  Terms of Service