setting xbee pro to 115200

 Digi's X-CTU utility only lets you set the buad rate up to 52600...

 I need to set my xbee's baud rate to match the APM baud rate of 115200..

anyone know how to do this?

 

Best,

Toby

 

Views: 89

▶ Reply to This

Replies to This Discussion

Permalink Reply by Ravi Gaddipati on December 2, 2010 at 7:41pm
that may be the limit. I can see 115200 on my 1W module.
Permalink Reply by Toby Stein on December 2, 2010 at 7:50pm
Hi Ravi,
I'm sorry, what's the 1w module?

ModeratorPermalink Reply by Chris Anderson on December 2, 2010 at 9:01pm
I'm not sure what Xbees those are, but if you used the ones we recommend in the manual that screen should look like this:


If for some reason you bought Xbees that don't go to 115200, you can set the Port 3 (telemetery) port to any speed you want in the APM_Config.h file. Here, I've set it for 38400:

#define SERIAL3_BAUD 38400

RSS

Contests

Season Two of the Trust Time Trial (T3) Contest has now begun. The third round was a reliablilty/aerial photography round for both planes and copters, which is now closed. Stay tuned for the next round, beginning soon.

A list of all T3 contests is here. 

 

Top Content 

1 What do you think the APM should do on fail safe

What do you think the APM should do on fail safe
2 ArduCopter 2.5 released!

ArduCopter 2.5 released!
3 Brainstorming Specifications.

Brainstorming Specifications.
4 Control Software

Control Software
5 Housekeeping note: Kevin Finisterre

Housekeeping note: Kevin Finisterre

Groups

© 2012   Created by Chris Anderson.

Badges  |  Report an Issue  |  Terms of Service