Moderator

Using xplane HIL without your radio?

I have been messing around with this, but unless i connect a my radio to the APM board it will never send any readings to Xplane?

Does anyone know if this is possible?

Views: 51

▶ Reply to This

Replies to This Discussion

Permalink Reply by Justin on August 28, 2011 at 5:29pm

I can get the setup into this state, but then I just hit "Sim Link Start/Stop" two times, and it comes good.

 

This with power to my receiver pulled. (and radio off).

 

Then I can give commands.

RSS

Contests

Season Two of the Trust Time Trial (T3) Contest has now begun. The third round was a reliablilty/aerial photography round for both planes and copters, which is now closed. Stay tuned for the next round, beginning soon.

A list of all T3 contests is here. 

 

Top Content 

1 What do you think the APM should do on fail safe

What do you think the APM should do on fail safe
2 ArduCopter 2.5 released!

ArduCopter 2.5 released!
3 Housekeeping note: Kevin Finisterre

Housekeeping note: Kevin Finisterre
4 Hexa-copter found after failed attempt of delivering cell phones to inmates of a Brazilian penitentiary

Hexa-copter found after failed attempt of delivering cell phones to inmates of a Brazilian penitentiary
5 Control Software

Control Software

Groups

© 2012   Created by Chris Anderson.

Badges  |  Report an Issue  |  Terms of Service