Xbee's Refuse To Communicate

I have my ArduPilot (running ArduPilot_EasyStar_V23) setup with an Xbee Series 2 on the Adafruit adapter board, with RX going to TX on the ArduPilot, 5v going to the special 5v Pin on the ArduPilot, and Gnd to Gnd.

On the other end, I have my ArduStation (running ArduStationV12) with a congruent (< :/ ) Xbee Series 2. They do not communicate, how can i start transmitting data? My Ardustation remains with 0's and both end's ASC LED's light up, but not the RSS LED's

Thanks
-Austin

Views: 80

▶ Reply to This

Replies to This Discussion

Permalink Reply by Austin Duff on September 21, 2009 at 12:19pm
It doesnt seem to work, I have a solid blue led indicating theres a gps fix but no coordinates show up on the ardustation, still 0's

RSS

Contests

Season Two of the Trust Time Trial (T3) Contest has now begun. The third round was a reliablilty/aerial photography round for both planes and copters, which is now closed. Stay tuned for the next round, beginning soon.

A list of all T3 contests is here. 

 

Top Content 

1 What do you think the APM should do on fail safe

What do you think the APM should do on fail safe
2 ArduCopter 2.5 released!

ArduCopter 2.5 released!
3 Housekeeping note: Kevin Finisterre

Housekeeping note: Kevin Finisterre
4 Hexa-copter found after failed attempt of delivering cell phones to inmates of a Brazilian penitentiary

Hexa-copter found after failed attempt of delivering cell phones to inmates of a Brazilian penitentiary
5 Control Software

Control Software

Groups

© 2012   Created by Chris Anderson.

Badges  |  Report an Issue  |  Terms of Service