Hello World! I made this little stuff in my kitchen. It's my third multicopter and it's controlled by an APM 2.5

I like the "H½" architecture, it's very strong resist. The washers made plastic tube are good dampers.

Pins are solder on the opposite side to use the APM like a shield on an pcb test mother board.

Same thing with the turnigy 9ch receiver.

Project.

1) Have a better english (I'm very sorry for the mistakes)

2) Change the central part of the frame to give more protection to the camera, 

3) Make a real PCB mother board for the ESC, AMP and receiver ....

Thank