reverse controls
apm1 3dr running in X. well i was flying it and i landed hard, went to refly it and now my controld are reverse.... i push stick right it banks left, i pull back it goes forward....Hmmm anyone seen this before?
Read more…glenn nafin's Discussions (6)
Sort by
update firmware
when we update the firmware should we erase the eprom and reconfig it all over.... or just load the new FW and go fly...
Read more…Propeller sizs
i was looking for some props at my local hobby shop and all they had were 12x3.8.... and i see on the order form when you pick what prop you want the 12 is 12x4.5...... think the 3.8 will work? i have the 880 motors in the 3d frame...
Read more…VSI is jumping
Hi my VSI gage is jumping aroung with the quad just sitting on the ground....am i missing something here? here is a vid..... and i have the latest FW on it.. Oh i do have a sonar on it but its the ez4...could this be it?
Read more…junk on screen when i log in to termimal..
when i open the termimal i get junk on the screen.... this normal?( Opened com port
Init ArduCopter V2.4.1
Free RAM: 3429 FW Ver: 116
load_all took 4808us
Press ENTER 3 times for CLI
GU ?EU "d '`? 8EArduCopter V2.4.1]
^^^^^^^^^^^^^^^^^^
this
Read more…Motors test on Arducopter 2.4.1
i loaded the new 2.4.1 on my quad with APM1 and when i do the motors test it spins motor 1 fast then motor 4 and then 2 and it spind 2 for about 5 sec... i am setup in X...
Read more…