"F11: Nice! I just didn't want to assume your aircraft configuration, but yes, if it is a stock ZII then you'd want to configure for elevons..."
Vast 303's Page
Latest Activity
Vast 303 commented on Chris Anderson's group ArduPlane User Group"@F11music.com
I don't have experience with that specific TX, but you need to get control surfaces to work properly in manual mode first. This is so you can always safely take over. Once you get that working, it is a matter of configuring APM…"
Vast 303 replied to Hawhoo's discussion Where would you install the airspeed sensor on a skyfun"I'd recommend installing it directly into the airstream, as far in-front of the fuselage as you can. The angular installation will cause errors due to blanking when there is some sideslip."
Vast 303 replied to Steve's discussion Xbee Causes Laptop/Desktop Cursor to be Non-operational"I had a similar problem in windows 7, but my mouse would jump around. XBee TM module showed up as Microsoft Serial BallPoint in device manager. Luckily my mouse still kinda worked, so I could just disable it and was good to go."
Vast 303 replied to W. D. Michael's discussion Mystery Ublox Hardware"W.D.-
What type of antenna are you using with your boards to get good RTK resuts?"
Vast 303 replied to Mike Goza's discussion ACM 2.2b2 compilation problems"I get the same error with Arduplane 2.28 and 2.27.
arduino-0022-relaxpatch works fine however..."
Vast 303 commented on Justin's blog post Russian 18th century Mathematician Vector Fields Guidance vs Now"How is the heading/roll autopilot different between the two navigation control law examples?
"
Anthony Wooldridge left a comment for Vast 303"Hi,
I bought a batch of these for my own purposes but can release some.
£50 GBP each as they are or £75 modified to run and power from usb port.
They are almost certainly the circuit board used in the evaluation kit but I can't say…"
Vast 303 replied to W. D. Michael's discussion Mystery Ublox Hardware"Is that board from the eval kit? I am interested in obtaining a LEA-4T board....Where did you stumble upon that board?
Thanks!"
Profile Information
- About Me:
- Interested in amateur UAVs!
- Tell us a bit about your UAV interest
- Interested in building a kinematic carrier phase tracking GPS sensor.
Comment Wall (1 comment)
- At 1:06am on June 4, 2011, Anthony Wooldridge said…
Hi,
I bought a batch of these for my own purposes but can release some.
£50 GBP each as they are or £75 modified to run and power from usb port.
They are almost certainly the circuit board used in the evaluation kit but I can't say for sure.
In any case they are equivalent in function. I can supply pinout and equivalent circuit information with them. If you buy the basic board from me I can supply details how to do the usb modification.
everything you need is on the board, antenna short circuit protection, backup capacitor ( although you might want to put a supercap there instead), voltage regulator for the LEA-4T chip. supply decoupling etc
Regards
Anthony
Contests
Season Two of the Trust Time Trial (T3) Contest has now begun. The third round was a reliablilty/aerial photography round for both planes and copters, which is now closed. Stay tuned for the next round, beginning soon.A list of all T3 contests is here.
Top Content
Groups
-
South African DIY Drones…
19 members
-
ArduPilot (legacy) User …
95 members
-
DIYDrones - CNC Project
60 members
-
Moderators
57 members
-
ArduCopter (traditional …
115 members
© 2012 Created by Chris Anderson.
