"I received my JD-IOBoard v1.1 today, cabled everything and things look somehow basically OK, but I did not figure out, how to configure/use JD-IOBoard with a X-frame type quadcopter properly.  The drawing in the Configurator shows for both…"

"hey, that's good to know, since I am thinking of upgrading from my Easystar I to the II and I like the camera pod. did you additionally adapt somehow the front of the pod to get a tight fit? thanks a lot, christian"

"is there already a plan, when JD-IO-Board Mavlink-Frsky conversion will include Voltage/Current from APM-Sensors (e.g. AttoPilot)? I saw that current version has prepared some code fragments, but they are commented out, since they seem not to be…"

"hmmm, I don't have any screen recorder running, but it seems from what I read on some articles and posts, that HIL simulation parameters (gains) vary between computers, so there might be a high impact on the performance of the system, meaning I…"

"hi there! I am trying to get HIL Simulation for Quadcopter working on my APM 2.5 with MissionPlanner 1.2.28 and x-plane 9.7 I have loaded the QRO_X from the starter package and it basically flies, but I am struggling quite heavy with PID and…"

"sorry, but I am not sure about that. this would be a question for the friends from 9xforums.com"

"Hola Anderl! Como estas? I don't really understand, what you mean with the non-telemetry Tx? I have the DHT DIY which has telemetry. Might be possible, that DJT and DHT requires different mods in the 9x. My understanding was that the…"

"exactly. you need a level converter. I did it that way: http://9xforums.com/wiki/index.php/How_to_modify_your_9x_to_support_telemetry#Using_FrsKy_Upgrade_Lite_as_Level_Converter for my first attempt and it works well. a bit tricky, but…"

"@Jani: Thanks for the information. However, I got it working without having to share Rx among several devices by following an advice…"

"got it! in case others have the same problem like me: check the following http://code.google.com/p/minimosd-extra/wiki/APM"

"in addition to what I am asking in my prior comment I found at http://code.google.com/p/arducam-osd/wiki/Troubleshooting which is most likely the reason for the problem: --------------------------------- Data is showing up only when…"

"Hi! I am using JD-IOBoard for Frsky Telemetry and I am a bit confused, if Rx should be shared with Telemetry, JD-IO and OSD? In fact my understanding was that OSD and JD-IO only require Tx (and +5V and GND of course). However, when having only Tx…"

"and the best of all: it's 22.12.2012 and the world is still here :-) greetings, christian"

"exactly! I started with that mod; however in the meanwhile I moved on to an sky9x-board for my 9x. This is a simple swap of the transmitters main board and you get tons of new features with that. My 9x is now more powerful as commercial 500 ++ USD…"

"yes, simply load the JD-IO Board firmware to the Arduino Pro Mini (using a FTDI and arduino on your computer) Power the Arduino Pro Mini with 5V and GND (e.g. from the receiver's pins). Then connect the arduino's D5 to the…"

"that's exactly what I am saying. I am using open9x since telemetry is much more advanced there. I have an arduino pro mini running the JD-IO software. this reads the sensor data from the APM or MPNG CAIOP and feeds the data converted in…"