"Jeslin,
Have you had any luck in your application of the Xbee Explorer Regulated on the APM?
Thanks!"
Jeslin Gan's Discussions
Xbee Help
Started this discussion. Last reply by John Church Oct 23, 2010. 8 Replies 0 Likes
Hi all, I had purchased the Xbee 1mW Wire Antenna modules from Sparkfun. Also, I am using the Sparkfun Xbee Explorer Dongle for the PC side while the ardupilot side is the Xbee Explorer Regulated.…Continue
Jeslin Gan's Page
Latest Activity
Jeslin Gan commented on remzibi's blog post Finally first working OSD firmware dedicated to Ardupilot"Hi all,
May I know whether the measured CRS data from GPS EM406 is accurate?
Thank you (:"
Jeslin Gan replied to Florin Mingireanu's discussion IR sensors-Ardupilot"Thanks for the help.
May I know which Ardupilot Code you are referring?
Thank you (:"
Jeslin Gan replied to Florin Mingireanu's discussion IR sensors-Ardupilot"Thanks for the help (:
Basically, what kind of values should we used if we want the pitch and roll value in the sense of degree? Also, how or where can we achieve the values from?
Jeslin"
Jeslin Gan replied to Florin Mingireanu's discussion IR sensors-Ardupilot"Thanks!
Usually what is the middle, minimum and maximum value of the sensors?"
Jeslin Gan replied to Florin Mingireanu's discussion IR sensors-Ardupilot"Sorry for interrupting.
Hi,
I went to research and found out that Z sensor is used for calibration. However, is there a need to do the calibration even though I am using XY and Z sensors. Also, if Z sensor is used for calibration, what kind of…"
Jeslin Gan replied to Keith's discussion Airspeed Measurement?"Hi,
As what you said,
Basically: groundspeed = GPS. Airspeed = pitot. Wind = pitot - GPS
May I know what is the purpose of static port? Also, what is the max and min value for the pitot tube?
Thanks for the help!"
Jeslin Gan replied to olli's discussion no connection possible with XBEE pro 2.5 60 mw"Hi,
May I know how do we interface the Xbee Explorer Regulated on the Ardupilot Shield with the Xbee Explorer Dongle on my PC? And can we connect the FTDI Cable directly to the Xbee Explorer Regulated?
Thanks for the help."
Jeslin Gan replied to Jeslin Gan's discussion Xbee Help"May I know how do we interface the Xbee Explorer Regulated on the Ardupilot Shield with the Xbee Explorer Dongle on my PC? And can we connect the FTDI Cable directly to the Xbee Explorer Regulated?
Thanks for the help (:"
Andre S replied to Jeslin Gan's discussion Xbee Help"I'm using the Sparkfun Xbee Explorer dongle on the ground station side with a 2.4GHz Xbee Pro 2.5 and the Mega with no problems so far. Under linux it just shows up as another ttyUSBX device. On the APM side I use the diydrones board. Then…"
Garry Qualls replied to Jeslin Gan's discussion Xbee Help"I wasted a lot of time on this very issue yesterday. It turns out that the XBee Explorer might have an issue with the 900 MHz XBee Pro. I found these two threads to be…"
Jeslin Gan replied to Jeslin Gan's discussion Xbee Help"Thanks for the reply, Scott.
However, I'm using the red Ardupilot so does it apply the same rule as ardupilot mega? Sorry I'm new here. Thank you."
Jeslin Gan posted a discussionXbee Help
Hi all, I had purchased the Xbee 1mW Wire Antenna modules from Sparkfun. Also, I am using the Sparkfun Xbee Explorer Dongle for the PC side while the ardupilot side is the Xbee Explorer Regulated. May I know do we configure only Xbee Explorer Dongle into PC in order to contact to the Xbee module?However, on the ardupilot side, how do we connect the Xbee to the Ardupilot Shield as I'm using the Xbee Explorer Regulated instead of the recommended Adafruit Xbee Adapter? Sorry as I'm new to wireless…See More
Profile Information
- About Me:
- I am interested in UAV.
- Tell us a bit about your UAV interest
- I am currently doing a project on UAV.
Comment Wall
- No comments yet!
Contests
Season Two of the Trust Time Trial (T3) Contest has now begun. The third round was a reliablilty/aerial photography round for both planes and copters, which is now closed. Stay tuned for the next round, beginning soon.A list of all T3 contests is here.
Top Content
Groups
-
ArduCopter Evolution Team
108 members
-
Moderators
57 members
-
UK Ardupilot Group
29 members
-
ArduPilot (legacy) User …
95 members
-
ArduCopter (traditional …
115 members
© 2012 Created by Chris Anderson.
