"Hi Again
I have just been reading through earlier posts on the site and have adjusted the pots on the control board and my display has popped up, so all is good.
cheers
John"
John Holloway's Discussions
Not seeing radio output through Ardupilot
Started this discussion. Last reply by John Holloway Jun 6, 2011. 4 Replies 0 Likes
HiI have just assembled the Ardupilot Mega full kit and have started testing it, all seems OK using the latest Ardupilot Mega planner (downloaded today), I can see all movements of the sensors in AC2…Continue
John Holloway's Page
Latest Activity
John Holloway replied to Toby Stein's discussion ArduStation Power Supply"Hi
I have just finished the assembly of the Ardustation and have uploaded the script, does the screen have to be powered separately as mine does not have any display when powered up.
Just to confirm I have connected a 9 volt power supply to the…"
John Holloway replied to John Holloway's discussion Not seeing radio output through Ardupilot"Thanks for all of the advice above, I thought it may be a "schoolboy error" it works a treat now!!!!!!
I don't suppose anyone flies anywhere near Cheshire.UK?
I look forward to to getting all the additional features working.
Many…"
Rui Manuel Cravo Marques replied to John Holloway's discussion Not seeing radio output through Ardupilot"Like said before, you must arm the motors pulling the throtlle to 0 and rudder full right, if you have the APM connected via USB, don't forget to connect the battery or you may burn your outputs or usb, since usb does not have enough power to…"
DeveloperOlivier ADLER replied to John Holloway's discussion Not seeing radio output through Ardupilot
"
You have to put the throttle stick lower right during more than 2 secondes to arm the motors. Be careful when doing this, disconnect ESC signal feeds."
Chris Whiteford replied to John Holloway's discussion Not seeing radio output through Ardupilot"You'll only see outputs after you arm the motors.
Basically until the code is actually sending a signal to the outputs it won't show up in the planner.
Just remember, make sure you don't have the motors powered up (or…"
John Holloway posted a discussionNot seeing radio output through Ardupilot
HiI have just assembled the Ardupilot Mega full kit and have started testing it, all seems OK using the latest Ardupilot Mega planner (downloaded today), I can see all movements of the sensors in AC2 Raw sensor screen, but when I go into the Radio tab I can only see movement of the radio on the left "Radio In" but no movement in "Radio Out". I am sure it is something simple (a bit like me) but anyone any ideas.Cheers JohnSee More
Profile Information
- About Me:
- I like anything that flies
- Tell us a bit about your UAV interest
- I like the objective of development and robotics
- Hometown:
- Crewe
Comment Wall
- No comments yet!
Contests
Season Two of the Trust Time Trial (T3) Contest has now begun. The third round was a reliablilty/aerial photography round for both planes and copters, which is now closed. Stay tuned for the next round, beginning soon.A list of all T3 contests is here.
Top Content
Groups
-
ArduCopter Evolution Team
108 members
-
Moderators
57 members
-
UK Ardupilot Group
29 members
-
ArduPilot (legacy) User …
95 members
-
ArduCopter (traditional …
115 members
© 2012 Created by Chris Anderson.
