"Has there been any development on this? I tried to see the www.AUV-Research.com site for details of the gimbal hardware but it only brings up a Joomla page. Any idea where the details have gone or where one can source the gimbal hardware"

"I really like this airframe. Does anyone have any details on this platform - aerofoil, engines, flight time etc."

"Where can one buy the 6lb plolyisocynaurate foam from ?"

"Dave, the link for the STEP version gives an error (unresolved URL). Can you please check or provide a different link please.  "

"I had to use different PCs as was having difficulties with frame rates. The Sim PC is already a bit overloaded :-(   But even on same PC has problem of data not going both ways. Will ask Michael about this.  "

"Yes please as it really helps to quickly find elevation of point particularly when planning changes on the fly."

"In version 1.0.68  in the Simulation screen under there "Advanced IP Settings" there is now the option (might have been in previous as well) to "Enter Sim PC port" and also "Enter Planner PC Port". Now in the…"

"I see that the latest version has two IP Ports settings for using the ArduPilot in HIL mode. What is the correct setting in X-Plane? As far as I could see the Wiki manual still shows the instructions for a single Port settings."

"I am sure that it has been tried by thousands of people and it works. And it is improbable that there is a common fault on all 4 boards (2 where bought ready soldered pins - 2 I soldered). So there must be a common problem that I am doing or arising…"

"I will try that code. I have 4 APM boards/IMU and all are doing the same - not likely but will check the IMU soldering. However something I did not mention is that when using the v1.0 boards I only get correct Channel PWM data in CLI mode if I set…"

"I have tried this on 3 difference PCs one with Win7 one with XP and one with Win2003 - all same result. Also tried downloading latest version of APM PM - same result."

"I am trying to load APM 2.2 for an aircraft autopilot through APM Mission Planner but it keeps getting stuck on "Checking APM version". I am using a APM v1.0 board with oilpan. So I cannot just try APM MP as suggested.  Just to…"

"I am trying to load APM 2.2 for an aircraft autopilot through APM Mission Planner but it keeps getting stuck on "Checking APM version". I am using a APM v1.0 board with oilpan. Just to confirm that everything is setup OK (cables, ports,…"

"The current images of the Planner on this thread and the Wiki show the dials and the WP details on the top portion The latest version of the Planner has them in tabs on the left below the HUD. Can this be changed from some config option or should I…"

"Chris, when in the top caption you said "If you change to Auto your mission will resume where it left off" can you please explain: 1. How does one switch back to Auto Mode after being in guided mode? 2. Where exactly will the mission…"

"Interesting project as it helps me in getting on the RF side of FPV, something that interests me a lot. Would be a great help if the schematics and board files are made available. Would be interested in two boards plus any indication where to…"