I am using APM version 1.1.87 on win7 64bit. The advanced parameter tab in the configuration tab shows wrong values.For example:1)      Both in parameter list (KFF_PTCHCOMP) and ArduPlane PID tabs (Pitch Comp) shows 0.23 while it shows 0.2 at the advanced parameter tab2)      Pitch to throttle mix shows 0.0 at the advanced parameter tab while it is 0.01 at the parameter list and ArduPlane PID tabs. Any idea which values it is actually use?How to report this bug so it will be fixed on the next…See More

Hello,I am using JR 2.4 Radio and set the RX failsafe to set RTL (if APM is connected) and engine off.So in case the APM is not connected the engine will be off (if I closed the TX before the RX). This is very important on electric motor setup.When APM is connected the failsafe will set the APM to RTL which is good but it is very danger when the radio lost is when the plane on the ground. In this case it will open the engine and ….The simple way to solve it is to check the ground speed and do…See More

Hello,I install APM planner 1.1.65 and the latest firmware 2.33 on APM 1 with airspeed, magnetic compus, gps, and Xbee communication.Since I update the firmware I retune the PID (FBW A) again and than starts the auto navigation.I have 2 problems with the setup and I will be appreciate it very much if you can advise me how to overcome the problems. 1)      On navigation program (auto) while turning more than 90 degree the plane is losing about 10m in height and regain it after it complete the…See More