Gender
Male
About
Location
Kungälb
About Me:
Born 1982 and allways been interrested in models and computers so i have a fev rc cars and a quad rotor.
Please tell us a bit about your UAV interest
Video capture and recreational RC fun
Hometown:
Kungälv
Activity Feed
"Same problem Osd stops working after giving to much throttle or using bigger props."
"40a is smalest esc with 6s
I'm still looking for an anwser if somone flies these plush 40a wit h6s and 380kv motors without problems."
I'm still looking for an anwser if somone flies these plush 40a wit h6s and 380kv motors without problems."
"Please can you moderator/developer guys start a thread that gives information about what high pole low kV motors work with what ESC. There are a lot of information out there but no concrete answer for what ESC and 6s work with what pole/kV."
"Im trying to find answer for what esc will work with 6s and 380kv 22pole motors."
"To make it better? But if the original software in the plush 40a can handle 22pole and 6s at 380kv with good throttle resolution there is no need. I ordered the multi star 4108 a few days ago NAD start reading about those sync issues. With simonk."
"Can you please update on this?"
"There is simply no documentation on how to impliment tri yaw servo. And I would like to hear from a developer the correct way to implement yaw servo."
"Its to get maximum travel without binding. But if you say so i can simply reset my rc trims and it will sit in hower angle because of the servo horn pisition. I was thinking the controller get to work overtime if its not setup level at center."
"There is noone who knows how to subtrim yaw servo?
I made a testflight it did not work with subtrim and mission planner rc vlaues the same.
Changed subtrim to 0 in radio kept subtrim in mission planner the tri flyes fine. But now i haw absolutely no…"
I made a testflight it did not work with subtrim and mission planner rc vlaues the same.
Changed subtrim to 0 in radio kept subtrim in mission planner the tri flyes fine. But now i haw absolutely no…"
I want to subtrim my yaw servo to 1650 because that is the place where it's centered.I get only half the trawel on the motor if it's centered at 1500.because of the servo horn. I put in new values on rc7 1250, 1650, 2050 but i see no difference when…
"I don't see the point of this function. I only had problems with apm gimbal servo output it gives random twitching and stuff unusable for video. I run opensource brushlessgimbal and have channel 8 connected to it bypassing APM for perfect results."
"I found a bug.
If you press reset button on the board andm ission planner is connected over 3dr link the board will not boot.
This is pretty annying having the computer inside my house on the seccond floor. Run inside and disconnect it go outsidr…"
If you press reset button on the board andm ission planner is connected over 3dr link the board will not boot.
This is pretty annying having the computer inside my house on the seccond floor. Run inside and disconnect it go outsidr…"
"I added a heavier camera to my quad. Now althold is compleatly messed up. it jumps up and down +-2m like a jojo motors behave frenettic throttle changes. No smooth throttle input changes to keep it in the correct alt.
where to start to make it give…"
where to start to make it give…"
"I see you hawe the same problem as me with thitching on servos.
I don't know if its the fault of servos hawing a little bit of play in the gearing or the APM code bei8ng faulty producing random twitching in the tilt accsis. Is there annoyone who…"
I don't know if its the fault of servos hawing a little bit of play in the gearing or the APM code bei8ng faulty producing random twitching in the tilt accsis. Is there annoyone who…"
"I did not read the whole post but powering servos on own battery and not grounding that power source to the boards powersource is a no go. The signal wire won't work if there is no common ground."
"I just had a crash in this version. The Multirotor started behaving realy strange. Can somone help me understand what happened. First the GPS behaved strange taking forever to lock. But I don't use it so I did not wait for more then 6stelites then…"
