Gender
Male
About
Location
jkpg
About Me:
FPV pilot, like electronics, arduino, programmin, designing, 3d printing etc..
Please tell us a bit about your UAV interest
http://www.youtube.com/user/petleh82
Activity Feed
"What plastic are you printing with ? PLA or ABS ? I print with PLA, and i have no heatbed, on my build platform i have blue painters tape. Also you might wan't to print the arm with the foot (circle) under, i did make it to stick better to the…"
"The PLA arms do not warp and they do not flex (i print them standing).. So far i have only printed in PLA, i don't know how they would be with ABS.. I have an Ultimaker, and i use replicatorg (0025) and skeinforge 35. There are newer versions but i…"
"I print with PLA plastics, and there is no issues at all, and the arms are very strong.. https://www.youtube.com/watch?v=RwZ5aTlU0iY"
I have released the second version of my 3D printable quadcopter the PL2Q Hugin, the first one was the PL1Q Vampire. There is a lot of improvements on this new version, also more focused at FPV and areal video.. You can download it from…
"Looks like it is supposed to look like a bird from the ground.."
"I now see that the tubes look different :-) that might explain it.. no hole in the top of one ?"
"Very nice ! But are the airspeed sensor correct mounted ? Am i wrong if i think only one tube should be on the front in the airflow and that the other should be not in the airflow, and the speed is the difference in pressure between the tubes ? Keep…"
"Very impressive ! To reduce time, you could build a magazine holding several GCPs (discs or small cones ore something) and have the multicopter first go and place them for you !"
