About

About Me:

About Me


Please tell us a bit about your UAV interest

I have an interest in UAVs.


Activity Feed

Wes Cravens posted a discussion
Hello all,I had a problem where one of my motors would just twitch when throttle was applied. It was debugged here: http://www.diydrones.com/forum/topics/one-of-the-motors-does-notYou should double check the soldering on your motor leads where they…
Jun 21, 2011
Wes Cravens replied to Wes Cravens's discussion One of the motors does not spin correctly.
"One of the wires going into the motor had a poor solder joint from the factory.
 
This was found by stripping off the heat shrink and inspecting the joint.
 
Repaired and the motor is working fine now.
 
 "
Jun 20, 2011
Wes Cravens posted a discussion
After swapping ESCs with an other arm it seems that it is motor related. The 'problem' stayed with the motor when two ESCs were swapped around. One again I also moved the signal connectors back and forth. All situations resulted in the same motor…
Jun 20, 2011