Gender
Male
About
Location
nsw
Please tell us a bit about your UAV interest
FPV, APM, long range
Hometown:
umina
Activity Feed
"Thanks Chris
Yes,I'm flying a plane.
I plugged ch5 from receiver to ch8 on APM inputs and it worked.
I got only 2 way toggle.
but looks like it only use one of my switches,the other one is not
activating any change in flight mode.
I have a futaba…"
Yes,I'm flying a plane.
I plugged ch5 from receiver to ch8 on APM inputs and it worked.
I got only 2 way toggle.
but looks like it only use one of my switches,the other one is not
activating any change in flight mode.
I have a futaba…"
HiI did radio calibration with no problem.The APM saw all my radio control and 2 switches on radio 5 and 6.But when I got to configure flight mode, nothing happens when I flick the switches.any suggestions?
"thanks again bblater for your comment.
I will try to connect the servos with all 3 wires it will much easier."
I will try to connect the servos with all 3 wires it will much easier."
"Thanks bblatter.
I've done more searches and reading and came up with this set up
I think it will be much safer for the plane.
any thoughts?
thanks"
I've done more searches and reading and came up with this set up
I think it will be much safer for the plane.
any thoughts?
thanks"
HiI'm Setting up my APM 2.5 system for my bixler 1.1 plane , and just not sure what BEC will be safeto power the board and the servos.I plan on using RCtimer current sensor and Turnigy Plush 30A ESC, and have jp1 on.I've added a diagram of how I…
